BYD ATTO3 Protective cover for charging port

Description

Tightly Waterproof :
Still worrying about water entering the charging port on a rainy day causing a short circuit? Our protective cover is made of high-density silicone with a double-layer seal around the edges to ensure that rainwater and car wash water can enter seamlessly, protecting your charging safety.
Effective dustproof :
Outdoor parking, dust, mud, sand and willow flakes are pervasive? One-piece full-wrap design, tightly fit the charging port, effectively blocking 99% of debris intrusion, refusing to cause poor contact or interface damage due to foreign objects.
Precise fit :
Refuse the incongruous auto parts city style! We use the original car 3D scanning data to open the mold, the curvature and size of the charging port with the original car tightly, installed as if the original factory comes with, perfectly integrated into the body design.
Durable :
Selected polymer polymerization material, flexible, fearless of sun and rain. Resistant to high temperature, cold (-40 ℃ to 120 ℃), long-term use of non-deformation, non-yellowing, non-cracking, a one-time investment, long-term protection.

Includes(skus)

1.BYD ATTO3 charging port cover (without tail number part number SC2E-8403840) 
2.BYD ATTO3 charging port cover (tail number/92 part number SC2E-8403840/92) 
3.BYD ATTO3 charging port cover (tail number A/92 part number SC2E-8403840A/92)

Installation steps

Step 1: Peel off the adhesive backing 
Carefully peel off the red or blue release film on the back of the cover, taking care not to touch the adhesive surface with your hands.
Step 2: Precise adhesion 
Gently apply the protective cover to the bodywork according to the pre-comparison position.Do not press hard yet! You can make fine adjustments to make sure the position is accurate and not skewed.
Step 3: Pressing Reinforcement 
After confirming that the position is correct, use the palm of your hand or a dry cloth to wrap your fingers and press the protective cover evenly and firmly from the center to all sides for more than 30 seconds to ensure that the adhesive backing and the bodywork are completely adhered to.