GWM Cannon Tray & Tub Accessories: The Buyer's Guide (2026)
The GWM Cannon's tub is where the work happens — and where the wear happens. Sliding cargo, dropped tools, sand, red dirt and the Australian sun all take their toll on a bare tub, and disorganised loads make the tray a pain to use.
The right accessories fix both: they protect the surface and make the tub easier to live with. Here's what actually earns its place — and how to choose fitment that won't damage your factory mounting points or your warranty.
- Tub liner or rubber mat — protects the surface from impact and scratches
- Sliding tray or drawers — reach gear without climbing into the tub
- Tie-downs / cargo rails — stop the load shifting on the move
- A tonneau or canopy — keep weather and dust out
Why a Bare Tub Needs Protecting
The factory tub finish handles light duty, but Australian use is rarely light. A few things wear it down:
- Sliding cargo — heavy items shift on braking and gouge the surface
- Sand and red dirt — abrasive grit works into every corner
- UV and heat — sun makes unprotected liners and plastics brittle over time
- Water — pooling around tie-downs and scratches is where corrosion starts
Protecting the tub isn't just about looks — a tidy, undamaged tub is far easier to sell on, so a bit of cheap protection pays back at resale.
The Core Accessories
Four categories cover almost every Cannon owner. Match them to how you actually use the ute:
| Accessory | What it does | Best for |
|---|---|---|
| Tub liner / rubber mat | Impact & scratch protection | Everyone — the baseline |
| Sliding tray / drawers | Reach gear without climbing in | Tradies, tourers, heavy loaders |
| Tie-downs / cargo rails | Secure the load on the move | Anyone carrying loose cargo |
| Tonneau / canopy | Weather, dust & security | Wet climates, valuable gear |
Sliding Trays & Drawers
If there's one upgrade that changes how you use the Cannon, it's a sliding tray or drawer system. Instead of climbing into the tub to drag gear out, you pull the whole load out to you.
- Access — reach tools and camping gear from the tailgate, no clambering
- Organisation — drawers keep kit sorted instead of sliding into one heap
- Protection — a quality tray spreads and contains the load off the bare tub floor
Load ratings vary widely by model, so check the specific tray's rating against what you carry rather than assuming. Many quality aluminium systems are designed for DIY fitting to the factory points, though a fitter is worth it if you'd rather not tackle the alignment yourself.
Aftermarket vs OEM
GWM's own accessories are well made and guaranteed to fit, but they're usually dearer and the range is narrower. Quality aftermarket gear often gives you more choice and better value — the key is that it's built to OEM-compatible standards.
- More choice and configurations
- Usually better value than OEM
- Often designed for DIY fitting
- Won't void warranty if OEM-compatible
- Guaranteed factory fit
- Factory branding & finish
- Usually the priciest option
- Narrower range of choices
Fitment & Warranty
The biggest myth in ute accessories is that anything aftermarket voids your warranty. It doesn't:
- Aftermarket is fine under Australian Consumer Law — a manufacturer can only decline a specific claim if a part is shown to have caused that fault
- OEM-compatible mounting is the safeguard — bolt to the factory points, don't drill or modify the tub or chassis
- Keep it sensible — don't overload beyond the tub's rating, and don't block drainage
Making It Last in Australian Conditions
Quality gear holds up to UV, dust and corrosion far better than bargain kit — and a little maintenance goes a long way:
- Rinse off grit — sand and dirt are abrasive; a periodic hose-out protects the surface and any moving parts
- Keep slides clean — for sliding trays, keep the rails free of grit so they run smoothly, especially after off-road trips
- Check fixings — vibration loosens bolts over time, so re-check mounting points now and then
- Choose UV-stable materials — cheap non-stabilised plastics go brittle in the sun; quality liners and dividers are built to resist it
Browse tub liners, sliding trays, tie-downs and cargo management for the GWM Cannon in our GWM Cannon range — OEM-compatible fit, built for Australian conditions.
Frequently Asked Questions
What accessories are compatible with GWM Cannon tub trays?
Tub liners and rubber mats, sliding trays and drawer systems, tie-downs and cargo rails, and tonneau covers or canopies. Choose Cannon-specific or OEM-compatible items that bolt to the factory mounting points rather than needing holes drilled.
How much weight can a Cannon sliding tray hold?
It depends entirely on the tray — load ratings vary a lot between models. Always check the specific product's stated rating against what you carry, and don't exceed it or the tub's own payload limit.
Do aftermarket tray accessories void the GWM warranty?
No. Under Australian Consumer Law, fitting quality aftermarket accessories won't void your warranty. GWM can only decline a specific claim if a part is shown to have caused that fault — so use OEM-compatible mounting and don't modify the tub or chassis.
What's the best material for Cannon tray accessories in Australian conditions?
Aluminium is popular for trays and drawers — light, strong and corrosion-resistant. For liners and dividers, look for UV-stabilised plastics or rubber that won't go brittle in the sun. Avoid cheap non-stabilised plastics that crack quickly in Australian heat.
Can I install tray accessories myself, or do I need a professional?
Many quality systems are designed for DIY fitting to the factory points, with basic tools. If a kit needs precise alignment or you'd rather not tackle it, a professional fit is inexpensive peace of mind — and avoids the risk of a crooked or loose install.
Aluminium or steel tray accessories — which is better?
Aluminium is lighter and more corrosion-resistant, which suits coastal and wet conditions and saves payload. Steel can be cheaper and very strong but is heavier and needs a good protective finish to resist rust. For most Cannon owners, aluminium is the easier long-term choice.
